Satellite Finder Digital Sat Signal Meter Strength High Accuracy Sensitive For Home Mobile Equipment Installation

This digital sat is microprocessor-controlled and thus reliable and accuracy. The digital sat-finder is very sensitive and can detect the lowest signals, the strong signals (strong satellite, large plants) can for a better. Through optimal adjustment, interference can be prevented by weather conditions. Ideal for satellite installation in the home and mobile equipment.

Features:
Controlled by microprocessor with reliable and accuracy measurement.
Very sensitive which can detect the lowest signals.
The interference by the weather conditions can be prevented through the optimal adjustment.
Suitable for satellite installation in the home and mobile equipment.
13V, 18V LED to indicate the polarization. You can adjust the polarization to achieve optimum signal level for both polarizations.
0Hz, 22KHz LED, the 22KHz signal of the receiver is commonly used to switch LNB frequency between high and low band. By switching the frequency on your receiver you can adjust the highest signal level on both frequencies with the satellite finder.

Operation:
Connect a jumper cable from the LNB/LNBF to the "TO LNB" connection on the Satellite Finder.
Connect the cable from your satellite receiver to the "TO REC" input on the satellite finder.
Turn on the satellite receiver. The satellite finder's scale should be lit at this time and the meter reading should be around 0.
Set your dish to the proper azimuth and elevation settings.
Set the satellite finder's scale reading to about 5 by adjusting the level control found of the Satellite Finder.
Peak the signal by slowly moving the azimuth and elevation of your dish. If the Satellite finder'reading becomes full scale adjusting the level control knob to reduce the reading to around 5 continute to move the dish until you have the highest possible meter reading and the highest possible buzzer pitch.
Optional feature: 13V, 18V LED to indicate the polarization. You can adjust the polarization to achieve optimum signal level for both polarizations.
Optional feature: 0Hz, 22KHz LED, the 22KHz signal of the receiver is commonly used to switch LNB frequency between high and low band. By switching the frequency on your receiver you can adjust the highest signal level on both frequencies with the satellite finder.
Remove the jumper cable and satellite finder and reconnect the LNB/LNBF to your receiver.

Specifications:
Frequency: 950-2150MHz
Power: 13-18V DC
Min. Input Level: - 40dBm
Maximum Input Level: - 10dBm
Input Impedance: 75 Ohm, F-connector
Output Impedance: 75 Ohm, F Connenctor
Betriebgsbereich: 52 - 60dB
Item Size: 110 * 65 * 40mm / 4.3 * 2.6 * 1.6in
Package Size: 125 * 85 * 50mm / 4.9 * 3.3 * 2.0in
Item Weight: 81g / 2.9ounce
Package Weight: 116g / 4.1ounce

Notes:
Please allow 1-30mm error due to manual measurement.
Due to the difference between different monitors, the picture may not reflect the actual color of the item.

Package List:
1 * Satellite Finder
1 * Manual